Clarion MONO CLASS D AMPLIFIER XC6120

XC6120

$340

NEED HELP? GET EXPERT ADVICE
(416) 282-8111



MONO CLASS D AMPLIFIER

330 Watts × 4 Continuous @ 4-Ohms
Adjustable - 12dB/Oct. Low Pass Electronic Crossover, 50Hz-500Hz
Bass Extender Control, 0-12dB at 45hz
Adjustable Infrasonic filter, 10-50Hz
Phase Control, 0-180 degrees
BC2 Remote Subwoofer Level Control included
Soft Turn-On and Turn-Off Circuitry
Audio Pass-Through outputs for additional amplifiers
Conformally Coated PC Board
Stainless Hardware
MOS-FET Power Supply
Ground Loop Isolation Circuit
Corrosion Resistant Nickel Plated RCA, Power, and Speaker Connections

Circuit Design Achieves High Quality Sound

Circuit Design Achieves High Quality Sound Clarion amplifiers feature uncompromising resistance to magnetic noise, thereby minimizing distortion, as well as high quality block terminals to offer low electrical and contact resistance. Easy subwoofer system configuration is possible with the embedded high pass and low pass filters. The result is high quality sound you can enjoy in a variety of systems.

Corrosion Resistant RCA and Block Terminals on all XC series Amplifiers

By utilizing corrosion resistant RCA and block terminals, XC series amplifiers offer improved durability and reliability in harsh environments. The XC series amplifiers are true marine amplifiers with oversized aluminum heatsinks and locking power terminals for the harsh marine conditions.

MOS-FET Power Amp

There’s only one way for Clarion’s main units to deliver unyielding power output and linearity: MOS-FET amplification, or Metal Oxide Semiconductor Field Effect Transistor amplification. Smaller and more efficient than conventional power supplies, a MOS-FET amplification circuit delivers power with less distortion and zero On/Off switching noise. This means you can crank up the volume or set it to easy listening. Either way, your sound will be crystal clear.

2-Ohm Stability

Utilizing this design for peak performance and unwavering reliability, Clarion’s amplifiers can drive lower impedance loads for increased power.

CEA 2006 Power Ratings
650W × 4 RMS [2Ω @ ≤ 14.4V 1% THD+N]
330W × 4 RMS [4Ω @ ≤ 14.4V 1% THD+N]
S/N 89dB (Ref: 1W into 4Ω)

leave your review


Four more than four decades G&G Electronics ......